Back to Home

Free Samples — These are only a portion of our complete database. All books and questions for various aircraft are available via WhatsApp.

📄 Sample Documents

Click any item to start download

Airbus A320 / A340 CMMs
Vendor CMMs (by ATA Chapter)
Boeing & Other CMMs

📝 Sample MCQs

Boeing 737NG
Q1: Which failure during an ILS approach causes the autopilot to disengage immediately?
  • A) Loss of both radio altimeters below 200 feet AGL
  • B) Loss of IRS data during localizer alignment
  • C) Course deviation exceeding 5 degrees
✓ Answer: A
Source: DFCS Manual | ATA-22 | Page 150
Q2: What does the FCC do if it identifies an erroneous radio altimeter signal during an ILS approach?
  • A) Disconnects autopilot
  • B) Uses a secondary radio altimeter
  • C) Ignores the altitude input
✓ Answer: B
Source: DFCS Manual | ATA-22 | Page 150
Q3: What role does the Mach Trim system play during high-speed flight?
  • A) Minimizes pitch fluctuations
  • B) Counters Mach tuck with nose-up elevator
  • C) Keeps pitch trim consistent
✓ Answer: B
Source: DFCS Manual | ATA-22 | Page 121
Airbus A320
Q1: What does the Terrain Clearance Floor (TCF) mode in EGPWS do?
  • A) Decreases terrain clearance
  • B) Increases terrain clearance above airport runway
  • C) Changes alert generation altitude
✓ Answer: B
Source: EGPWS Manual | Page 106
Q2: Which feature is added in the "ENHANCED" functions of EGPWS?
  • A) Terrain Awareness Alerting and Display (TAD)
  • B) Automatic avoidance maneuvers
  • C) Speed monitoring
✓ Answer: A
Source: EGPWS Manual | Page 106
Robinson R44 Helicopter
Q1: What care should be taken when cleaning the exterior of an R44 helicopter?
  • A) Avoid high-pressure water near main rotor/static ports
  • B) Use solvent-based solutions
  • C) Blow compressed air into drain holes
✓ Answer: A
Source: Maintenance Manual | CH.23 | Page 23.1
Q2: Which defect requires immediate rejection of a part during Magnetic Particle Inspection (MPI)?
  • A) Linear indications >0.125" angled >15°
  • B) Discoloration in test fluid
  • C) Minor surface roughness
✓ Answer: A
Source: Maintenance Manual | CH.23 | Page 23.28